USAfixTM - Repair Guide (RG) - Master

Email RG

- Check the wiring between the terminal block and the solenoid valve

Level of Difficulty - HIGH	Estimated Completion Time - 15 minutes
TASKI - FG 2C
	Tools Required Tool   Screwdriver-phillips Volt meter (True RMS capable)
	Parts Required

Step   Procedure & Parts & Tools 1 LAY THE MACHINE DOWN WITH THE FRONT COVER FACING UP. REST THE MACHINE ON BOARDS SO THAT THE FILTER ON THE BACK DOESNT GET BROKEN. 2 REMOVE THE 4 SCREWS AND LIFT UP ON THE FRONT COVER TO REMOVE IT. Screwdriver-phillips 3 REMOVE THE SCREW HOLDING THE TERMINAL BLOCK. REMOVE THE TERMINAL BLOCK FROM THE MACHINE AND PULL THE 2 WIRE CONNECTORS OFF THE SOLENOID VALVE. Screwdriver-phillips 4 PLACE THE LEAD IN THE TERMINAL BLOCK WHERE THE WIRE IS AND PLACE THE OTHER LEAD IN THE WIRE CONNECTOR AS SHOWN. SET THE VOLT METER TO CONTINUITY. IF THE VOLT METER BEEPS, THE WIRE IS GOOD. REPEAT FOR OTHER WIRE. Volt meter (True RMS capable) 5 IF WIRES ARE OKAY, REVERSE STEPS 1 THRU 3 TO REASSEMBLE THE MACHINE.